Introducing the S7R

 

The S7R is designed to be compact yet offer a bass extension that borders on the line of requiring a sub for the majority of monitoring situations. Incorporating a 6.5” low frequency driver with a double flared front loaded port design means reduced turbulence and a monitor that is very forgiving of placement to walls. The built in amplification provides a total of 190W RMS to the drivers. Power is split with 120W RMS to the 6.5” LF and 70W RMS to the silk dome tweeter. Attenuation to the input sensitivity along with low and high frequency is available on the rear panel. The operating range is 65 Hz – 20 kHz with a +- 2db tolerance. The With the addition of the SB10R the frequency response can be taken down to 27Hz for those wanting to accurately monitor down to the lowest of usable acoustics frequencies.

Download the specification

TECHNICAL SPECIFICATION

Dimensions:                 244(w) x 347(h) x 302(d) mm

Weight:                        11.7 kg / 25.5 lb

Drivers:                        Bass cone – 1 x 165 mm (6 ½ ”)

High Frequency soft dome – 1 x 28 mm (1 ⅛”)

Maximum SPL:          105 dB continuous pink noise @ 1 m LEQ 1 min

Frequency Response:  68 Hz-20 kHz ± 2 dB / 58 Hz-22kHz -6 dB

Connector:                   XLR and ¼ inch Jack combo socket

Impedance:                 10k W electronically balanced with RF filters

Wiring: 

  • Pin 1 ground Sleeve
  • Pin 2 hot Tip
  • Pin 3 cold Ring

Sensitivity:                   -12 dBu to +6 dBu for 96 dB SPL @ 1 m set by 10 position rotary switch on rear

Subsonic:                     -3dB @ 30 Hz, 24dB/oct

Ultrasonic:                   -3dB @ 75kHz, 4dB/oct

Crossover:                   1k19

LF EQ:                          -2/-4 @ 65 Hz

HF EQ:                         +/- 2dB @ 10 kHz

POWER AMPLIFIER

LF output power:         120W RMS continuous (note 1)

HF output power:        70W RMS continuous (note 1)

THD:                               0.03% at levels up to 1 dB below clip, 20 Hz-20 kHz. Typ 0.005% @ 1kHz.

Hum & Noise:             -100 dB referred to clip

NOTE 1: The continuous rating is for a period not exceeding 5 minutes with unrestricted airflow (100 mm clearance) around the amplifier heatsinks and an ambient temperature not exceeding 30ºC.

INDICATORS

Power on:                    Front mounted green LED indicates power applied.

Clip:                             Red LED 2 dB before amplifier clip.

POWER REQUIREMENTS

Voltage:                       Set by internal plugs: nominal 115V or 230V @ 50-60 Hz AC 230V setting: min 160V; restricted output power: max 255 AC 115V setting: min 80V; restricted output power: max 127V

CONSUMPTION

Quiescent:                   18W

Typical use:                  75W (average music)

Max:                             140W (average music)

Note:  0 dBu = 775 mV into open circuit

This product is built to conform to the requirements for CE marking.

All Quested Products come with a five year warranty.

Experience the S Series